40.68MHz Dielectric-Heating Lift

Alltite Lifting in Seoul
올타이트 · 2026 Guide

A Korean-made lift that borrows a technology from cancer care — it tightens the dermis and SMAS without numbing cream, and leaves your facial fat alone.

Overview

What Is Alltite Lifting?

If Ultherapy sounds too painful and Thermage didn’t do much for your jawline, there’s a name you’ll keep hearing in Seoul clinics right now: Alltite (올타이트). It’s a lifting device from the Korean start-up INNOXUS that heats the dermis and the SMAS layer with 40.68MHz shortwave energy. Most clinics do it without numbing cream in about 20–25 minutes, and a full face (300–400 shots) costs roughly ₩500,000–₩770,000 in Seoul — well under half the price of Ultherapy or Thermage.

Two things to know before you book. Alltite is approved by Korea’s Ministry of Food and Drug Safety (MFDS), but it is not FDA-cleared in the US (as of November 2026), and no celebrity has publicly said they’ve had it yet. Its story lies elsewhere: a Korean doctor took a heating technology used in oncology and turned it into a lifting device.

Alltite lifting device by INNOXUS — console with touchscreen and two handpieces
The Alltite system by INNOXUS (Korea): one console, two handpieces.
Alltite at a glance
What it is
Non-surgical lifting device using 40.68MHz shortwave dielectric heating (DLTD)
Made by
INNOXUS, Seoul, Korea (founded 2022) · model INX-23001
Targets
Mid-to-deep dermis + SMAS; the fat layer absorbs very little energy
Pain & time
Usually no numbing cream — feels warm · 20–25 minutes
Downtime
Mild redness or warmth for a few hours; makeup the same day
Results
Tighter right away, collagen builds over 2–3 months, lasts about 6–12 months
Seoul price (2026)
300 shots ₩500,000–730,000 · 400 shots ₩650,000–770,000 (VAT incl.)
Approvals
Korea MFDS approved · not FDA-cleared (Nov 2026)
How It Works

So What Makes Alltite Different?

Every lifting device does the same basic job: it heats tissue under the skin so collagen contracts and then rebuilds. The difference is how it heats. HIFU devices like Ultherapy and Shurink focus ultrasound into tiny points of 65–70°C — like a magnifying glass concentrating sunlight. RF devices like Thermage use the resistance heat of an electric current, which is strongest near the surface where the electrode touches. That’s why both can feel hot and sharp.

Alltite takes a third route. It applies a 40.68MHz shortwave electric field, so water molecules and ions inside the tissue rotate, realign and generate heat themselves. This is called dielectric heating — the same principle long used in deep-heat physiotherapy and tumor hyperthermia. The key point: heat doesn’t travel inward from the surface; it is created inside the target layer.

The clever part is that skin layers absorb this frequency very differently. The dermis and the SMAS absorb it well, while subcutaneous fat barely does — according to the manufacturer, heat concentration in the fat layer is about 1/17 of the dermis. In plain words: the layers that hold your face up get heated, and the fat that keeps your cheeks full is skipped. That’s exactly why people who felt “hollowed out” after HIFU are asking about Alltite. A dual cooling system keeps the skin surface cool the whole time, so many clinics skip numbing cream altogether.

INNOXUS was founded in 2022 by Dr. Shim Jae-yong, a Seoul National University medical graduate, and Alltite is its first product. Interestingly, buyers from Japan, Hong Kong and Brazil signed for 300+ units after seeing demos — before the official Korean launch. Japanese clinics now introduce it as “Alltite from Korea,” six patents including the core DLTD technology have been filed internationally, and Korean doctors presented it at the Korean Society for Laser Medicine and Surgery (2025) and the Korean Association of Plastic Surgeons (2026).

Alltite E-type and D-type handpieces side by side
Alltite’s two handpieces — E type (left) and D type (right). Clinics use both during a session to heat the dermis and SMAS.
🔬
Dielectric Heating (DLTD)
40.68MHz shortwave makes tissue heat from the inside, not from the surface
🎯
Dermis + SMAS
Reaches the same lifting layer as HIFU while also firming the dermis
🧊
No Numbing, 20–25 Min
Dual cooling protects the skin; most clinics skip numbing cream
🛡
Fat-Sparing Design
Heat in the fat layer is about 1/17 of the dermis (manufacturer data)
Who It’s For

Who Is Alltite a Good Fit For?

Woman with a firm, defined jawline — illustrative model image
Illustrative model image — not an actual Alltite result.
  • You’ve put off lifting for years because Ultherapy or Shurink pain scares you
  • Your face is lean or your skin is thin, and you worry a lift will leave your cheeks hollow
  • You’re in your mid-30s to 50s, and your jawline is starting to blur and your cheeks to drop
  • Fine lines and overall loss of firmness bother you more than heavy sagging — the manufacturer names this as its first target
  • You need to be back at work or out sightseeing the next day
If sagging is already advanced, Alltite alone may not be enough — it’s worth discussing HIFU or a surgical consult as well. Alltite is not suitable during pregnancy, or if you have metal implants or an electronic device such as a pacemaker in or near the treatment area.
Results

What Results Can You Expect?

Areas people treat with Alltite
  • ✓Jawline & V-line definition
  • ✓Mild cheek sagging
  • ✓Sagging above the smile lines
  • ✓Fine lines around eyes & mouth
  • ✓Overall firmness & skin texture
  • ✓Neck (at some clinics)

The line you’ll see most in Alltite reviews is “my face felt tighter the moment I walked out.” That’s the heated collagen fibers in the dermis and fascia contracting on the spot — but it’s only the start. The real change comes over 2–3 months as new collagen fills in, and results are generally described as lasting 6–12 months, depending on the person.

Clinics differ on scheduling: some recommend 3 sessions 4 weeks apart, others 1–2 sessions a year. Either way, decide with your doctor based on how much laxity you have.

An honest note: unlike EMFACE or Sofwave, Alltite doesn’t have published clinical figures such as “37% fewer wrinkles” yet — it has been on the market for less than two years. What exists today is design data (the 17× difference in fat-layer heating) and the experience of adopting clinics, and this page won’t claim more than that.
Procedure

How an Alltite Session Goes

About 30–40 minutes door to door. Protocols vary slightly by clinic.

Doctor performing Alltite lifting along a patient’s cheek and jawline
An Alltite session: the handpiece glides along the cheek and jawline while you lie back. Most clinics skip numbing cream.
1
Consultation
3D skin analysis; choose 300, 400 or 600 shots
2
Cleanse & mark
Numbing cream usually skipped (optional)
3
Alltite treatment
D- and E-type handpieces heat dermis and SMAS, 20–25 min
4
Cool & soothe
Calming mask or recovery ampoule
5
Back to your day
Makeup right away
Before & After

Before and After Your Alltite Treatment

Simple rules, but they make a real difference to comfort and results.

Before your session

  • Pause retinol, AHA and other strong actives, plus peels and laser, for 1–2 weeks
  • Avoid heavy drinking the night before
  • Tell your doctor about any filler, Botox or thread lift in the past 2–4 weeks
  • Let them know if you are pregnant, breastfeeding or prone to keloids
  • Mention any active cold sores (herpes) or dermatitis in the area
  • Metal implants or electronic devices (e.g. a pacemaker) must be disclosed

After your session

  • Mild redness, warmth or slight swelling can last a few hours to a day
  • For 2 days: skip sauna, hot baths, hard exercise and alcohol
  • For about a week: no peels, scrubs or strong facial massage
  • Moisturize well and use SPF diligently; makeup is fine the same day
  • If pain persists or blisters appear, contact the clinic right away
Compare

Alltite vs Ultherapy, Thermage & Shurink

The maker’s pitch is “the depth of Ultherapy + the firmness of Thermage + no pain.” The fair verdict today: half proven, half still being validated.

DeviceHow it heatsHow it differs from Alltite
Ultherapy · Shurink (HIFU)Focused ultrasound points in the SMASStronger lift but more painful; energy passes through fat, so hollowing is possible
Thermage FLX (monopolar RF)Resistance heat from electric current in the dermisGreat for firmness and wrinkles and FDA-cleared, but pricier, with surface heat
Oligio · Coolfase (Korean RF)Same resistance-heat approach as ThermageMainly the dermis; Alltite also reaches the SMAS
Alltite (shortwave dielectric)Heat generated inside tissue; fat layer skippedPros: no numbing, instant tightening, keeps volume. Cons: no long-term data or FDA clearance yet

Seoul clinics use Alltite on its own, but you’ll also see half-and-half packages with a HIFU such as LinearZ or Shurink — “ultrasound for deep sagging, Alltite for firmness and fine lines.” Pairing it with a skin booster on the same day is common too.

Who’s Talking

Any Celebrities Who’ve Had Alltite?

Not yet. As of November 2026 we couldn’t find any Korean or international celebrity who has publicly said they’ve had Alltite. This device spread among doctors first: overseas buyers ordered it after seeing demos, about 200 units sold within 10 months of the Korean launch, and investors including Altos Ventures put ₩14.2 billion into the company. If a celebrity campaign starts, we’ll update this page.

Price

How Much Is Alltite in Seoul? (2026)

Alltite is priced by shot count. These are 2026 public event prices from clinics in Gangnam, Songpa and Hongdae — all VAT included. Note that the tax refund for foreign patients ended in January 2026, so there’s no cosmetic-treatment refund at the airport anymore.

Public event prices listed by Seoul clinics, Nov 2026. VAT included; varies by clinic.
PackageSeoul public price (2026)
100 shots (trial)₩209,000~
200 shots₩418,000–429,000
300 shots (face)₩500,000–730,000
400 shots (standard face)₩650,000–770,000
600 shots (face + neck)₩990,000~
Price Range₩450,000 – ₩1,000,000 / session
Sessions1–3 sessions / year
Priced by shot count

Even at the same 400 shots, prices differ depending on whether a dermatologist treats you personally and whether 3D analysis and soothing care are included — compare like for like. Japanese booking apps list a Seoul clinic’s 240 shots at around ¥39,600; in Japan itself Alltite is still an unapproved device brought in by personal import, so options there are limited.

FAQ

Alltite FAQ

Neither, strictly speaking. It uses 40.68MHz shortwave dielectric heating, which creates heat differently from standard RF, and like HIFU it reaches down to the SMAS layer.
Most clinics do it without numbing cream, and people describe it as a warm sensation. If you’re sensitive to pain, you can ask for numbing cream.
The manufacturer designed heat in the fat layer to be about 1/17 of the dermis, so the risk of volume loss is structurally low. Where and how many shots are placed still matters — tell your doctor which areas you’re worried about.
A tighter feeling right after, collagen rebuilding over 2–3 months, and results that typically last 6–12 months.
A full face is usually 300–400 shots; adding the neck makes it about 600 shots.
Alltite is approved by Korea’s MFDS (model INX-23001) but is not FDA-cleared as of November 2026. It is exported to Japan, Hong Kong and Brazil, and the maker is preparing for North America and Europe. Note: “AliTight” (K231146) in the FDA database is a different company’s device.
Yes. A common Seoul combination uses HIFU such as Ultherapy for deep sagging and Alltite for firmness and fine lines.
Next Step

Find a Clinic & Compare Prices

Find Clinics Price Guide